Description
A selection of three standard commands will be found at the bottom of most every command panel. These standard terminating commands (Figure 2.57) will in all
instances represent the same action and have consistent, relevant Undo level results:
- OK: Saves any pending changes and closes the command panel. This operation creates a new Undo level. The shortcut
for OK is Ctrl+Enter.
- Cancel: Drops any pending changes and closes the command panel. This operation does not create a new Undo level. The shortcut
for Cancel is Esc.
- Apply: Saves any pending changes and keeps the command panel open for additional work. This operation creates a new Undo
level. The shortcut for Apply is Ctrl+Shift+Enter.
The OK, Cancel, and Apply commands are present in most command panels.